Pioneer CNDV-40R, Operating Manual

Page: 96 / 120

94
Appendix
When the installation is complete, the open-
ing display appears.
6
Press the NAVI/AV button to change the
navigation screen.
Some time is needed until navigation is ready.
7
Check the details of the cautionary mes-
sage and click the OK button.
8
To set the time difference, select “+” or
“–” and click the OK button.
The time difference between the time origi-
nally set in the navigation system (Pacific
Standard Time) and the current location of
your vehicle is shown. If necessary, adjust the
time difference. Selecting “
+ ” or “ – ” changes
the time difference display in one-hour incre-
ments. The time difference can be set from
+3 to –3 hours.
9
If necessary, select “Summer Time” and
set to summer time.
Daylight Saving Time (DST) is off by default.
Select “
Summer Time ” and click the OK
button to change the time if you are in the
daylight saving period. This turns the display
below DST “
On ”.
10
To complete the setting, select “Back”
and click the OK button.
The map of your surroundings appears.
This completes the setup of your Navigation Sys-
tem. Chapter 1 explains the basic operation of
your Navigation System.
➲
To change the language and time later
➞
Page 51
If You Have Changed the Sys-
tem Configuration
If you have replaced the remote control or config-
ured another display (or AV Head Unit) in the sys-
tem, several settings must be changed in order
for the system to work normally.
Read the appropriate section carefully before
using the navigation system.
About the Dipswitch Setting of
the Remote Control
This manual describes the operation based on
the Remote Control “CD-R11”. According to the
Remote Control you are using, some button
names of the Remote Control may be different
from this manual.
Time difference