Pioneer CB-A802, Service Manual

Page: 108 / 168

DVD-V8000
108
1 2 3 4
1 2 3 4
C
D
F
A
B
E
7.5 SERIAL NUMBER SETTING
The serial number of this unit is stored in the EEPROM on the AJKB Assy. When the AJKB Assy is replaced, serial number
setting is also required. The remote control unit for service is used for setting.
Press ESC then the 9 key to enter Serial Number Setting mode.
Move the cursor to a digit where an alphanumeric is to be entered, using the REP.A or REP.B keys. Enter an alphanumeric,
using the SPEED – or SPEED + keys.
After all necessary alphanumerics are entered, press the SEARCH key. The indications shown below will be displayed. If the
setting is correct, press the SEARCH key again. The serial number will be written to the EEPROM.
To exit Serial Number Setting mode without writing the set serial number to the EEPROM, press the CLEAR key.
Note:
As a serial number, from the first to the 4th and 11th to 12th digits from the left are reserved for uppercase alphabetics only,
and from the 5th to 10th digits are reserved for numerics only.
How to set