JACKIE L
USER’S GUIDE
Edition 24. January 2022
18 / 28
Ev.n. 2-20220124-rev.10
PINNIUM
s.r.o., Za Pazdernou 2573, 397 01 Písek
CIN: 109 01 442 EU VAT No.: CZ10901442
8.
Pump up and down using the main rod. The lifting Tool will climb the rising joist up
and start to tilt the wall.
Those steps of lifting the wall goes on from horizontal position of the wall up to the angle
of 80-85
°
at maximum. The remaining angle 5-
10° is already possible to tilt up to 90 degrees
by your hand. Do not forget to secure the wall against falling down, see Chapter 5.5.
The wall tilting and manipulation with the lifting Tool during the remaining angle 5-
10°
is shown in the Chapter 5.5 and 5.7.
NOTICE:
The lifting Tool contains two levers. Main rod (O) and auxiliary lever (P). Main lifting movement
of the wall is reached by pumping with the Main rod up and down.
In case of the rising joist is thinner or slightly worn in some point or slightly out of the tolerance,
it may cause some slipping of the Tool on the rising joist in this point. There is an auxiliary
lever (P) to get over this point by pushing the auxiliary lever (P) down by your hand
and pumping the main rod (O) in the same time. If the rising joist is damaged or the
thickness is too small, we highly recommend to do not use this joist for lifting the walls.
Figure 17
8.
..
Figure 16
