Introduction
6
RC-PRO Panel Description
The RC-PRO (seen in Figure 1) is a state- of- the-art Narrow-Band wireless receiver,
designed to operate with the HUNTER-PRO control panel via its serial interface.
This wireless receiver supports up to 16 zones with wireless detectors (i.e., PIR,
Reed Switch, etc.) and up to 18 remote control units (used to arm/disarm the
system, activate accessories and send a panic signal).
The RC-PRO turns the HUNTER-PRO into an hybrid system that can be
connected to wired and wireless detectors.
The HUNTER-PRO can be configured as follows:
♦
Eight to sixteen wired zones (with or without an expansion card)
♦
Eight wired plus eight wireless zones (using only zones 1 to 8 in the RC-PRO)
♦
Sixteen wireless zones
The receiver has the unique ability to “learn” the wireless devices’ codes.
Installing and programming wireless devices is easily done. The detectors
transmit Alarm, Supervision, Low Battery, and Tamper signals.
The RC-PRO has the following inputs, outputs, indications and buttons:
ON
DIP
1
2 3
4 5
6 7
8
TAMPER
PROGRAM
RX
VALID
RUN
GND 12V
Antena
ADD
DELETE
IN
OUT
ON
DIP
1
2 3
4 5
6 7
8
Figure 1 - RC-PRO General Layout (cover removed)
