Connecting to a Control Panel
14
Adding a Detector / Panic Button
IMPORTANT!
When adding a detector to a zone that was previously programmed with a different one,
the new detector shall override the old one.
When adding a detector that was previously programmed with a different zone, the old,
duplicate, programming shall be automatically erased.
To add more then one Panic Button to a single zone, the first should be programmed as
a standard detector and all other Panic Buttons’ code should be set with theirs internal
dipswitch (see Figure 2).
1,2,3...
Set a switch according to the zone to be
programmed in dipswitch Bank1 & Bank2 to
ON. E.g., for programming zone 6, set
switch #6 in Bank1; for programming zone
10, set switch #2 in Bank2 (see opposite
figure)
ON
DIP
1
2 3
4 5
6 7
8
Bank1
ON
DIP
1
2 3
4 5
6 7
8
Bank2
The YELLOW PROGRAM LED should turn ON
PROGRAM
NOTE:
If the YELLOW LED flashes, check that only one switch (in both dipswitch Banks) was set to ON.
Press the ADD button
ADD
The RED VALID LED should start flashing
VALID
Trigger the wireless detector
2
Once the receiver successfully learned the
detector’s code, the RED VALID LED stops flashing
VALID
Set the switch in dipswitch Bank1 and
Bank 2 back to OFF
ON
DIP
1
2 3
4 5
6 7
8
Bank1
ON
DIP
1
2 3
4 5
6 7
8
Bank2
2
The PIR is triggered by pressing and releasing the TAMPER switch, the PANIC
button is simply pressed, and the Reed Switch is triggered by bringing the two
parts close together and apart again.
