Programming the RC-U
22
SuperVsn
is the interval (in hours) that the control panel is expecting to receive a
supervision signal from each of the wireless detectors. If a signal is not received
within this time frame, a failure shall be recorded in the system’s history log
(memory) and a System Response is issued (as programmed in Response to Zone
Failure - see the HUNTER-PRO installation manual).
NOTE:
As wireless PIR transmit supervision signal approximately every 3 hours, the
programmed interval should be more then 3 hours.
Setting 0 (zero) as the supervision interval shall disables this feature.
NOTE:
When the supervision interval is set to anything but 0 (zero), all “empty zones” (i.e.,
zones which are not linked to wireless devices) must be permanently bypassed in the
zone characteristic programming. Failing to do so will cause a Supervision Lost
indication and reporting.
g
Example1:
Installing 8 wired zones with 8 wireless zones. Zones 9,10,11,12 and 13 are linked to
wireless detectors. Zones 14, 15, and 16 are left unlinked and thus must be bypassed.
g
Example2:
Installing 16 wireless zones. Zones 1 to 12 are linked to wireless detectors. Zones 13 to 16
are left unlinked and thus must be bypassed.
Press
ENTR
followed by
END
until the clock is displayed on
the LCD (i.e., normal user operation mode)
