Connecting to a Control Panel
16
Low Battery and Tamper Reports
Low Battery Report
The wireless detectors automatically transmit a Low Battery report to the RC-PRO
wireless receiver when the batteries voltage level is low (i.e., batteries are nearly
dead). The Low Battery report code is transmitted immediately after a standard
supervision code, or, if the tamper switch is triggered (i.e., the detector casing
was opened).
Low Battery Restore is transmitted after the tamper switch is triggered on the
wireless detector. This is done regardless of the battery voltage level. However,
the detector immediately after, checks the voltage level and when below the
threshold, transmits the Low Battery report code again.
Tamper Report
The state of the tamper switch (open/closed) in a wireless detector is transmitted
on power-up.
The Tamper Open code is sent whenever the front case is removed and the
switch is released. The receiver Tamper Closed code is sent whenever the front
case is closed and the switch is depressed again.
