RC-PRO
Wireless Receiver for
HUNTER-PRO
- Installation Manual
23
ro
u
b
le
sh
o
o
ti
n
g
a
n
d T
e
st
s
T
T
ROUBLESHOOTING
AND
T
ESTS
Test Modes
There are two Test Modes. The first is a Walk Test, designed for testing all the
detectors; the second is a Tamper Test, designed for a single detector test.
1,2,3...
To enter the Test Modes:
[
Master Code
→
#
RESET
The display shall show:
E n t r = T e s t
W L
a l l
N E X T = T a m p e r
O n l y
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Walk Test
→
ENTR
to start the Walk Test Mode
When activating the Walk Test mode, the wireless detectors’ messages are
displayed on the LCD with each valid message received by the RC-PRO. The
message is displayed along with the detector’s name and RSSI level. In addition,
the buzzer in the keypad is activated, and its audible frequency is proportional to
the RSSI level.
NOTES:
While in Walk Test mode, a blinking ‘
W
’ is displayed on the LCD.
This mode is only valid for 10 minutes. Should Walk Test be repeated, the above
procedure must be carried out again.
To stop this mode press and hold the
END
key.
