PIKA Mosport 1E-F, Hardware Installation Manual, Page: 53 / 64

Mosport 1TE/2TE 43
A
P P E N D I X
D
Interface Card Installation
Instructions
This Appendix describes how to install interface cards in a Mosport 1TE/2TE unit.
General Information
This assembly instruction is generic to any model of interface card.

Some of the steps are optional, depending on the model to be assembled.

The pictures shown in this Appendix are for reference only.

The specification of the screws used in this assembly instruction are:
• 615-00023-00G: Screw #4-40 3/16" Flat Head Phillips 70% Undercut Stainless Steel
• 615-00039-00G: Screw #4-40 1/4" Pan head Phillips Stainless steel internal lock SEMS
Interface Card Installation Instructions
Follow these instructions with care.
1. Remove ALL cables connected to the unit prior to start working.
The Mosport 1TE/2TE series has internal AC/DC power supply and telephony interfaces with
hazardous sections accessible when the cover is removed. It is imperative for your own safety to
remove all cables connected to the unit prior to start working.
2. Remove the screws of the ear mounting brackets on each side of the unit (keep them for re-
assembly of the casing).
3. Remove all the screws of the top casing.
There are three screws located on the top side, three screws located on the bottom side, and one
screw located on each side (keep them for re-assembly of the casing).
4. Slide the top casing to remove it from the unit.
5. Remove the screws of the “SLOT2” and/or “SLOT3” plate where you want to install the new card
(keep them for re-assembly of the casing).
Note:
When installing a mix of digital interface card and analog interface card, ALWAYS install the digital
interface card in “SLOT2”.