PIKA Mosport 1E-F, Hardware Installation Manual, Page: 19 / 64

Required Mounting Tools and Equipment Hardware Installation Guide
Mosport 1TE/2TE 9
General Safety Practices
Follow these guidelines to ensure personal safety and protect the equipment:

Keep the Mosport 1TE/2TE clear and dust-free during and after installation.

Locate the emergency power-off switch for the room in which you are working. Then, if an
electrical accident occurs, you can act quickly to turn off the power.

Disconnect all power before installing the Mosport 1TE/2TE.

Do not work alone if potentially hazardous conditions exist.

Never assume that power is disconnected from a circuit. Always check.

Do not perform any action that creates a potential hazard to people or makes equipment
unsafe.
Preventing Electrostatic Discharge Damage
Always follow electrostatic discharge (ESD) prevention procedures when installing or working around the
Mosport 1TE/2TE.

Ensure that the Mosport 1TE/2TE chassis is electrically connected to earth ground.

Wear an ESD-preventive wrist strap, ensuring that it makes good skin contact. Connect the clip
to earth ground to channel unwanted ESD voltages to ground safely. If no ESD wrist strap is
available, ground yourself by touching the metal part of the chassis.
Required Mounting Tools and Equipment
You will need the following tools and parts to properly install the Mosport 1TE/2TE:

Screwdriver as required for attaching brackets to rack or wall.

Philips screwdriver for attaching brackets to the Mosport 1TE/2TE.

Screws and anchors for wall-mounting, if required.
• Four wood screws or other fasteners, for installing the chassis on a wall.

ESD-preventive wrist strap.
In addition, you might need the following external equipment:

Modem for remote access.

RJ-45 cables for the WAN and LAN connections.
Unpacking and Inspection
If you haven’t already done so, unpack the Mosport 1TE/2TE device. Carefully remove it from the package
and packing material. The Mosport 1TE/2TE package contains the following items:

1 x Mosport 1TE/2TE unit

1 x power cord for the country in which you are using the Mosport 1TE/2TE

1 x wall/rack mounting kit

1 x Bumpon
TM
kit for desktop use

3 x 10/100 BaseT Ethernet RJ-45 cables (Mosport 1E-F/1TE)

5 x 10/100 BaseT Ethernet RJ-45 cables (Mosport 2E-F/2TE)

1 x printed Installation quick start
Warning:
This equipment must be installed and maintained by service personnel. Incorrectly connecting
this equipment to a general-purpose outlet could be hazardous. The telecommunications lines must be
disconnected before unplugging the main power connector.