PIKA Mosport 1E-F, Hardware Installation Manual, Page: 16 / 64

Chapter 1 - Overview Port Numbering Convention
6 Mosport 1TE/2TE
Port Numbering Convention
The following describes the port numbering conventions of the Slot sections.
WAN/LAN Slot – Ethernet Connectors
The following describes the port numbering conventions of the Ethernet connectors.
Figure 5: Ethernet Connectors Port Numbering Conventions
Service Slot 1
This slot is currently unused.
Service Slots 2/3 – PRI Connector
Each slot has only one PRI connector. This connector has software configurable pin outs, and can be set in
either Network or User mode.

User mode: The connector emulates the subscriber (terminal) side of the digital connection.
You can connect the SCN to the connector.

Network mode: The connector emulates the central office (network) side of the digital
connection. You can connect a PBX to the connector.
Refer to the Software Configuration Guide for more details. Also refer to “E1 PRI RJ-45 Cable” on page 33 for
information on the proper cabling.
11. LINK Indicates the state of the ISDN network connected to this connector:
• Yellow LED: The connection has a Loss of Signal (LOS).
• Green LED: The connection works properly.
Table 7: PRI Models Rear Panel LEDs (Continued)
LED Description
Standards Supported • IEEE 802.3: LAN/MAN CSMA/CD Access Method
• EIA/TIA 568-A: Commercial Building Wiring Standard
LAN
Connector
#1
LAN
Connector
#3
LAN
Connector
#2
LAN
Connector
#4
WAN
Connector
Note:
The LAN connectors are used to contact the unit on the LAN side. They can also be used as a SIP
gateway to be bound on the LAN. However, there is no routing between the LAN and the uplink interface.
Standards Supported • EIA/TIA-464-B: Requirements for Private Branch Exchange
(PBX) Switching Equipment
Note:
Service Slot 3 is available only on the Mosport 2E-F/2TE models.