PIKA Mosport 1E-F, Hardware Installation Manual

Page: 23 / 64

Location and Mounting Requirements Hardware Installation Guide
Mosport 1TE/2TE 13
6. Repeat steps 3 to 5 for the bracket on the other side of the Mosport 1TE/2TE.
PIKA recommends to place the second bracket in the opposite corner to the first bracket for
increased stability.
7. Position the Mosport 1TE/2TE against the wall (or plywood) with the front and rear panels vertical.
Figure 10: Wall-Mount Installation Example
8. Attach the Mosport 1TE/2TE to the wall (or plywood) with screws (not provided) to ensure that it is
secure.
9. Proceed to “Hardware Installation” on page 14 .
Free Standing Unit
When installing the Mosport 1TE/2TE on a desk or table, it should be located at least 20 cm from your monitor,
computer casing or other peripherals, including speakers. Never put books or paper on the Mosport 1TE/2TE.
You must also apply the Bumpon
TM
authoadhesive protective products to the bottom of the Mosport 1TE/2TE.
These will stabilize the Mosport 1TE/2TE and offer skidding resistance.
Condensation
When bringing the unit into a warm environment from the cold, condensation may result that might be harmful
to the unit. If this occurs, allow the unit to acclimatize for an hour before powering it on.
Cleaning
To clean the Mosport 1TE/2TE, wipe with a soft dry cloth. Do not use volatile liquids such as benzine and
thinner that are harmful to the unit casing.
For resistant markings, wet a cloth with a mild detergent, wring well and then wipe off. Use a dry cloth to dry
the surface.