Chapter 2 - Installation
Hardware Installation
14
Mosport 1TE/2TE
Hardware Installation
This section describes how to set the connectors of the Mosport 1TE/2TE.
See
“Appendix B - Cabling Considerations” on page 31
for more details on the cables the Mosport 1TE/2TE
uses.
Connecting Cables
The following describes how to connect the various cables to the Mosport 1TE/2TE.
Figure 11:
Hardware Installation
To install the cables:
1.
Before you begin, be sure that the Mosport 1TE/2TE is powered off.
2.
Create a WAN connection by connecting a 10/100 BaseT Ethernet RJ-45 cable into the
ETH5
connector of the Mosport 1TE/2TE.
The other end of the cable is connected to the WAN via a modem or other means.
See
“Ethernet RJ-45 Cable” on page 31
for more details on this cable.
3.
If you want to contact the unit via its LAN side, connect a 10/100 BaseT Ethernet RJ-45 cable into
either the
ETH1
,
ETH2
,
ETH3
, or
ETH4
connectors of the Mosport 1TE/2TE. Connect the other end
to a computer.
See
“Ethernet RJ-45 Cable” on page 31
for more details on this cable.
4.
Create an ISDN connection by connecting an E1 RJ-45 cable into any of the two
E1 / T1
connectors
of Slot 2/3 sections of the Mosport 1TE/2TE (Slot 3 is available on the Mosport 3632 model).
•
If you are using the Mosport 1TE/2TE with a PBX, connect the other end of the cable to
the PBX.
•
If you are using the Mosport 1TE/2TE with the PSTN, connect the other end of the
cable to a proper PSTN outlet.
5.
Connect the power cord to the Mosport 1TE/2TE and then connect the other end to an electrical
outlet.
You are now ready to start the Mosport 1TE/2TE.
Caution:
The Mosport 1TE/2TE must be installed on a circuit equipped with a breaker so that you can
easily power the unit off if required.
Warning:
To avoid electrical shock, apply the following instructions:
•
The device must be installed by technical personnel.
•
Be sure the ground path is connected.
Slot 3
Slot 2
Slot 1
Basic Slot
2
3
4
4
5
Warning:
The electrical outlet must be installed near the Mosport 1TE/2TE so that it is easily accessible.
Summary of Contents for Mosport 1E-F
