Installing the DDM/Network Interface Board
C-25
Connecting the Live100 MVIP Cable
For the Live100 product, connect the DDM/Network Interface
board to the Audio Communications board by using the supplied
ribbon cable with a 40-pin connector on each end.
Caution
Use care when connecting the MVIP cable to the board so as
not to damage the pins.
To connect the two boards using the MVIP cable, follow these steps:
1. Grasp the connector on one end of the ribbon cable.
2. Line up the key on this connector with the slot on the expansion
connector attached to the front of the Live100 Audio
Communications board.
3. Slide the key into the expansion connector s Repeat these steps
to connect the other end of the ribbon cable to the Network
Interface board.
Live100 MVIP Cable
Live50 CHI to MVIP Cable
(Part #510-0167-01)
(Part # 180-0293-01)
