83
83
83
83
How to execute Self-test
This test procedure provides more tests for the hardware of M3510A/11A
than the power-on tests.
Do the procedure SHIFT + CONFIG > SYSTEM > ENTER > SELF TEST >
ENTER to start the self-test.
After self-test procedure, the result, PASS or FAIL, will be shown on the
display. If the result is FAIL, the “ERR” annunciator on the display panel
will be lit, and error codes will be stored. You can check the errors by
following the procedure in the section 4.4.7 Error Condition.
Self-test error codes
The descriptions of self-test error codes are listed below.
601 Front Panel failed
The communication with the front panel is failed when proceeding with
the self test.
602 Input does not open
There are sources input. It’s not allowed when doing self test. You have
to remove all leads from the terminals.
603 A/D offset failed
When proceeding with A/D test, the deviation exceeds “Zero” too much.
607 Rundown too noisy
When gaining the A/D readings, values are inaccordant due to noisies.
609 DC gain x1 failed
Readings are incorrect when going through the path
gain x 1
.
610 DC gain x10 failed
Readings are incorrect when going through the path
gain x 10
.
613 SenseHi Path zero failed
The reference point “Zero” is incorrect when getting readings through
