Picomed PicoPhone, Documentation

Page: 17 / 22

PicoPhone loudspeaking analog telephone Page 17.
equipment.
Very low volume in the
speaker.
Volume set to minimum.
Device is covered.
Hook off, press ”F”.
Remove covering.
Does not respond to IR-
remote controller.
IR-glass in front of device
is covered.
Wrong IR-signals.
Remove covering.
Reprogram or do IR-
training once again.
There are no fuses inside the device which shall be replaced.
6.1 When errors arise
If there are errors which are not possible to solve, contact your supplier of the equipment, or
the national distributor. Please make a note beneath of the telephone number to your supplier.
Name Telephone number, adress etc.
Supplier:
National distributor:
7 Technical information
The device is made by:
Injection moulded box in recycleable ABS.
Frontglass made of plexiglass (Polycarbonat).
2 PCBs: a maincard in bottompart with contacs, and a keypad PCB mounted in top-part.
Microphone and loudspeaker mounted in rubber gaskets to dampen mechanical vibrations.
Frontfoil. Productname, lightindicators and keys are visually viewed on it.
7.1 Fixed mounting
PicoPhone are designed to be placed on a flat surface, or it can be hanged vertically with the
help of the built-in screwholes.
Ensure that cables not are crushed between the device and surface.
The microphone is placed in the line between top and bottom part of the unit. When
placed vertically on a wall, pay attention to the attenuation of the users voice if the unit
are placed lower than the users mouth.
A drilling template is made and attached at the end of this documentation.
7.2 Electrical connections
Severe terminal strips are placed inside the box.
Connections are made for cables of size 0,14-1,5 mm
2
(35-16 AWG).
Remove insulation = 6 mm.
The figure beneath shows the position for terminal strips, contacts and jumpers.
7.2.1 Fixed 12 VDC and external IR-sensor
0V 0 V.
+12V +12 VDC fixed. Ment for IR-sensors and bell buttons. I < 65 mA.
LED Controls LED on external IR-sensor(s).