Picomed PicoPhone, Documentation

Page: 14 / 22

PicoPhone loudspeaking analog telephone Page 14.
28
1,2
Stored digit/
Empty
–, nnn (-)
Pressed digit D
Saved
Activate voicemessage(s).
(End conversation with outdoor unit)
29
1
Stored digit/
Empty –, nnn (-)
Pressed digit D Saved Activate voicemessage(s) for situation 1.
(Answer telephone)
30
1
Stored digit/
Empty –, nnn (-)
Pressed digit D Saved Activate voicemessage(s) for situation 2.
(End telephone conversation)
31
1
Voice input D Saved Record auditive feedback words.
4.3.1
1
) Additional explanations for the table above
16 When a lockcode is activated for a given key, then the other IR-format(s) will be
deactivated for the actual key.
21-23 To record word/sentences press and hold the "F" key, talk the message, and release
the key. The recording stops when the key is released, or the available time of 5
seconds are used. Then a long ”beep” appears, and the recorded message will be
played back. The speech will be stored while recording it, not when pressing the ”D”
key.
Recording should be done in a silent environment with a clear voice with the mouth
near the microphone which is situated in the left front corner of the device.
26-30 To activate a message, you may enter one, two or three digits (value 1,2 or 3) for
each situation in the prefered order. The value indicates the number of the voice
message. A description of each situation are given in chapter 3.4.5. A voice message
has to be recorded before it can work.
31 Recording shall be done in this sequence:
"0-9", "*", "#", "Empty", "Saved", "Error" and "Pause".
Record one word and listen to the playback. Each word may be played back several
times if necessary. If not approved, you may record again. There is 1 second
available for each word. The following keys shall be used while recording:
F Record one word. Do it in the same way as described in point
21-23. OBSERVE: Read also text for key ”B/#”.
A Playback a recorded word.
B Go to next word in the sequence. If the last word is recorded,
("Pause") there will come 3 short ”beep” and the device are
ready to record the first word ("0") in the sequence again.
D Finish the sequence.
Start with "0", go on with ”1” and so on. ”Pause” is the last word.
Important!
When installing a PicoPhone you should as a first job enter advanced
programming mode and record speech to the auditive feedback (point 31 in
the list). This should be done because this feedback will be a very good help
in programming mode.
Remember to activate auditive feedback in point 04 if this shall be active in
ordinary use of the equipment.