PICOLAS LDP-QCW 300-12, User Manual

Page: 40 / 41

40
Description of the LSTAT Register Description of the LSTAT Register Description of the LSTAT Register Description of the LSTAT Register
The following list contains a description of the individual LSTAT bits. These can be read with the
GETLSTAT and written with SETLSTAT command.
Bit
Bit Bit
Bit Name
Name Name
Name Read/Write
Read/Write Read/Write
Read/Write Meaning
Meaning Meaning
Meaning
0 L_ON r/w Enables / disables the output.
1 ISOLL_EXT r/w When “1”, the external current set
point is used
2 ENABLE ro Indicates the state of the ENABLE
pin of the BOB connector.
3 MASTER_ENABLE ro Indicates the state of the
MASTER_ENABLE pin of the BOB
connector.
4 PULSER_OK ro When the bit is read “0” an error
has occurred
5 DEF_PWRON r/w When “1” the device load its
default values on power-on
6 INIT_COMPLETE ro When “1” the internal power-on
sequence is complete
7-8 TRG_MODE r/w Trigger mode:
0 : external pulse input
1 : internal pulse generator
2 : external controlled
3: not used
9 TRG_COUNT r/w When “1” the counted mode is
active
10 TRG_EDGE r/w When “1” the positive edge is used
11 OVERCUR_EN r/w Enabled / disables the over current
protection
12-13 REG_MODE r/w Regulator mode:
0 : manual
1 : semi-automatic
2 : not used
3 : not used
14-31 Reserved ro Reserved