PICOLAS LDP-QCW 300-12, User Manual

Page: 36 / 41

36
GETREPRATEMAX GETREPRATEMAX GETREPRATEMAX GETREPRATEMAX
Returns the maximum possible repetition rate of the internal pulse generator. This value depends of
the current pulse width. Hence, any change in the pulse width changes this value too. It is measured
in [Hz].
SETREPRATE SETREPRATE SETREPRATE SETREPRATE
Sets the repetition rate of the internal pulse generator to the given value. It must be within the
borders defined by GETREPRATEMIN and GETREPRATEMAX. The value is measured in [Hz].
GETCOUNT GETCOUNT GETCOUNT GETCOUNT
Returns the number of pulses the internal pulse generator will generate as soon as it becomes
enabled. This is only used if the counting mode is enabled. See chapter “trigger modes” for more
information.
GET GET GET GETCOUNT COUNT COUNT COUNTMIN MIN MIN MIN
Returns the minimal number of pulses the pulse generator can produce if counting mode is enabled.
GETCOUNTMAX GETCOUNTMAX GETCOUNTMAX GETCOUNTMAX
Returns the maximal number of pulses the pulse generator can produce if counting mode is enabled.
SETCOUNT
SETCOUNT SETCOUNT
SETCOUNT
Sets the number of pulses the pulse generator will generate to the given value. It must be within the
borders defined by GETCOUNTMIN and GETCOUNTMAX.
GETFFWD GETFFWD GETFFWD GETFFWD
Returns the actual feed forward voltage used by the current regulator. See chapter “current
regulator” for more information. It is measured in steps of 0.01[V]
GETFFWDMIN GETFFWDMIN GETFFWDMIN GETFFWDMIN
Returns the minimal feed forward voltage used by the current regulator. It is measured in steps of
0.01[V]
GETFFWDMAX
GETFFWDMAX GETFFWDMAX
GETFFWDMAX
Returns the maximal feed forward voltage used by the current regulator. It is measured in steps of
0.01[V]
SETFFWD SETFFWD SETFFWD SETFFWD
Sets the feed forward voltage used by the current regulator to the given value. It must be within the
borders defined by GETFFWDMIN and GETFFWDMAX. See chapter “current regulator” for more
information. The value is measured in steps of 0.01[V]
GET GET GET GETCAP CAP CAP CAP
Returns the actual pre charge voltage of the capacitor bank. See chapter “current regulator” for more
information. It is measured in steps of 0.1[V]
GETCAPMIN GETCAPMIN GETCAPMIN GETCAPMIN
Returns the minimal pre charge voltage of the capacitor bank. It is measured in steps of 0.1[V]
GETCAPMAX GETCAPMAX GETCAPMAX GETCAPMAX
Returns the maximal pre charge voltage of the capacitor bank. It is measured in steps of 0.1[V]