PiC indolor ONE CHECK, Instruction Manual

Page: 18 / 116

18 19
Applying the Cuff
1. Plug in the cuff connecting tube into the unit.
2. Wrap the arm cuff, leaving the end of the cuff around the cuff.
3. Put your left arm through the cuff loop. The colour strip indication should be positioned closer to your
elbow with the tube pointing in the direction of your arm. Turn your left palm upward and place the
edge of the arm cuff at approximately 1.5 to 2.5 cm above the inner side of the elbow joint. Tighten
the cuff by pulling the end of the cuff.
4. Centre tube over middle of arm. Press the hook and loop material
together securely. Allow room for 2 fingers to fit between the cuff and
your arm. Position the artery mark over the main artery (on the
inside of your arm). Centre tube over middle of arm.
Note: Locate the main artery by pressing with 2 fingers approximately
2 cm above the bend of your elbow on the inside of your left
arm. Identify where the pulse can be felt the strongest. This is
your main artery.
5. Lay your arm on a table (palm upward) so the cuff is at the same
height as your heart. Make sure the tube is not kinked.
6. This cuff is suitable for your use if the arrow falls within the solid
colour line as shown on the right. If the arrow falls outside the solid
colour line, you will need a cuff with other circumferences. Contact
your local dealer for additional size cuffs. (small REF 00 022013 200
000 – medium REF 00 022013 250 000 large REF 00 022013
300 000)
Notes:
1. To stop the measurement at any time, press one of the buttons under
the display. The cuff will quickly deflate
2. Store the cuff carefully
Main artery
Main artery
Cuff tube