PIAGGIO Beverly Tourer 125, Service Station Manual

Page: 66 / 278

switch is set to « OFF ». It remains activated for 48
hours in order not to affect the battery charge.
When the ignition switch is turned to « ON », the
deterring blinker function is deactivated. Subse-
quently, a flash confirms the switching to « ON ».
The duration of the flash depends on the electronic
control unit program (see figure).
In case the LED turns off and remains so even
when switching over to « ON », check if:
- there is battery voltage
- 15A main fuse (No. 7) is in working order.
If the deterring LED remains off, check the control
unit power supply as follows:
- Disconnect the control unit connector. Check if:
- There is battery voltage between terminal No. 4
(Red/Black) and the ground lead
- There is battery voltage between the terminal No.
4 (Red/Black) and terminal No. 8 (Negative) as
shown in the figure.
- There is battery voltage between the terminals
No. 5 and No. 8 with the key switch set to « ON »,
the side stand folded up and the emergency cut-
off switch set to « RUN ».
If no faults are found, replace the control unit; oth-
erwise, check the wiring and the following compo-
nents:
- Engine stop remote control;
- Emergency cut-off switch;
- Side stand contacts;
- Key switch contacts.
Electrical system
Beverly 125
ELE SYS - 66