PIAGGIO Beverly Tourer 125, Service Station Manual

Page: 179 / 278

- Using two 24 mm wrenches, tighten the screw
until the seat and the bearing are fully set in place.
N.B.
ALWAYS USE A NEW BEARING AND A NEW SEAT.
Specific tooling
001330Y Tool for fitting steering seats
Rear
Removing the rear wheel
- Remove the muffler support bracket
- Remove the 5 screws shown in the photograph
Refitting the rear wheel
- Carry out the removal operations but in reverse order, observing the prescribed tightening torques.
Locking torques (N*m)
Fixing screw for wheel rim to hub 34 ÷ 38
Swing-arm
Removal
- Place the scooter on its centre stand;
- Support the engine adequately;
- Loosen the nut shown in the figure and pull out
the spindle from the left-hand side.
Beverly 125
Suspensions
SUSP - 179