PIAGGIO Beverly Tourer 125, Service Station Manual

Page: 47 / 278

Discharge: 0.15 mm (when cold)
Cooling system
Level check
- To check the level, it is necessary to look inside the expansion tank: a mark on the side of the filler
indicates MIN and MAX levels.
Top-up
Check coolant level when the engine is cold as in-
dicated in the scheduled maintenance table, fol-
lowing the steps below:
Place the scooter on its centre stand and on flat
ground.
- Undo the screw shown in the figure and remove
the expansion tank cap on RHS.
- Remove the expansion tank cap « A » and top-up
if the fluid level is near or below the MIN level ref-
erence mark in the expansion tank. The coolant
level must always be between MIN and MAX. lev-
el.
-The coolant consists of an ethylene glycol and
corrosion inhibitor based 50% de-ionised water-
antifreeze solution mix.
CAUTION
DO NOT EXCEED THE MAX. LEVEL WHEN FILLING SO AS
TO AVOID THE COOLANT ESCAPING FROM THE EXPAN-
SION TANK WHEN THE vehicle IS IN USE.
Beverly 125
Maintenance
MAIN - 47