NOTICE
Overheating caused by unfavorable nominal current
specified nominal current (p. 33)
applies when operating at room temperature. The
nominal current needed for operating the V-408 must be adjusted when the ambient
temperature rises. Otherwise the V-408 could be damaged by overheating.
►
Calculate the nominal current according to the ambient temperature.
►
Adapt your application (acceleration, speed, load) so that the calculated nominal current
is not exceeded. If you have any questions, contact our
NOTICE
Excessively high or wrongly connected operating voltage!
Excessively high or wrongly connected operating voltages can cause damage to the V-408.
►
Pay attention to the
operating voltage range (p. 34)
, which is specified for the V-408.
►
Pay attention to correct
NOTICE
Heating up of the V-408 during operation!
The heat produced during operation of the V-408 can affect your application.
►
Ensure sufficient ventilation at the place of installation.
►
Ensure that the effective nominal current and the peak current do not exceed the
permissible values.
NOTICE
Damage from transport safeguard that has not been removed!
Damage can occur to the V-408 if the transport safeguard of the V-408 has not been removed
and a motion is commanded.
►
Remove the transport safeguard before you start up the V-408 and electronics system.
NOTICE
Unintentional change in position due to missing self-locking!
The drive of the V-408 does not have self-locking. The V-408 can therefore move
unintentionally in the following cases:
■
Switching off the controller
■
Rebooting the controller
■
Switching off the servo mode for the axis
■
Switching off the drive for the axis
■
Safety switch-off by the controller due to overtemperature or overcurrent
Unintentional changes of position can damage the V-408, the load to be moved, and the
surroundings.
►
Operate the V-408 only with a horizontally aligned motion axis.
►
If you want to operate the V-408 with a vertically aligned motion axis: Attach suitable
gravity compensation (not in the scope of delivery). Contact our
for details on gravity compensation.
►
Before switching off or rebooting the controller, take suitable measures to ensure that
unintentional changes in the position of the motion platform are not possible.
7 STARTUP / OPERATION
V408M0001EN
‒
2/17/2020
25
M O T I O N | P O S I T I O N I N G
