NOTICE
Damage due to collisions!
Collisions can damage the V-408, the load to be moved, and the surroundings.
►
Make sure that no collisions are possible between the V-408, the load to be moved, and
the surroundings in the motion range of the V-408.
►
Do not place any cables or other objects in areas where they could be caught by moving
parts.
NOTICE
Protruding screw heads!
Protruding screw heads can damage the V-408.
►
Make sure that the screw heads are fully countersunk and cannot interfere with motion.
NOTICE
Excessively long screws!
The V-408 can be damaged by screws that are inserted too deeply.
►
Pay attention to the
depth of the mounting holes (p. 35)
in the V-408.
►
Only use screws with the correct length for the respective mounting holes.
Mounting the V-408 onto a Surface
1. Place the V-408 on the surface so that the corresponding mounting holes in the V-408 and
the surface are in line.
Optional: Use the locating holes provided for aligning.
2. Insert the screws into all accessible mounting holes and tighten.
For mounting from above:
a) Move the V-408's motion platform by hand until the countersunk holes in the base
body are accessible.
b) Mount the V-408 over the four countersunk holes in its base body.
■
Maximum torque: 0.6 Nm
For mounting from below:
a) Mount the V-408 over the M3 holes, see the gray arrows in the figure above.
■
Maximum screw-in depth: 6 mm
■
Maximum torque: 1.1 Nm
3. Check that the V-408 is affixed firmly to the surface.
6.2
Mounting the V-408 with Adapter onto the Optical Table
Tools and Accessories
■
V-500.AP1 adapter, available as
■
Screws in the scope of delivery of the adapter:
■
4 screws ISO 4762, M6x10, A2
■
4 screws ISO 4762, M2.5x10, A4-70
■
2 locating pins ISO 2338, 3h8x6, A2
■
Suitable screwdriver
Requirements
✓
You have read and understood the
general safety instructions (p. 8)
✓
The optical table flatness is
≤
20 μm.
6 INSTALLATION
V408M0001EN
‒
2/17/2020
16
M O T I O N | P O S I T I O N I N G
