Optional: For aligning, use the two locating pins and the locating holes provided, see
the figure above.
b) Mount the adapter onto the lower positioner with four M2.5×10 screws.
■
Maximum torque: 0.6 Nm
c) Check that the adapter is fixed firmly.
2. Mount the upper positioner onto the adapter, see the figure above.
a) Put the upper positioner on the adapter so that the corresponding mounting holes in
the upper positioner and the adapter are on line.
Optional: For aligning, use two locating pins and the locating holes provided, see the
figure above.
b) Move motion platform of the upper positioner by hand until the countersunk holes in
the base body are accessible.
c) Mount the positioner with four M2.5×10 screws over the four countersunk holes in the
base body, see
.
■
Maximum torque: 0.6 Nm
d) Check that the upper positioner is fixed firmly.
6.5
Mounting the Load onto the V-408
Overview
Figure 8: Position of the mounting holes for fixing the load
Figure 9: Mounting holes for fixing the load onto the side
The arrows mark the following holes in the sides and in the platform of the V-408:
6 INSTALLATION
V408M0001EN
‒
2/17/2020
21
M O T I O N | P O S I T I O N I N G
