Debugging
© PHYTEC Meßtechnik GmbH 2002 L-462e_2
61
4.4
Starting the Debugger
•
Before starting the Debugger on the host-PC, press the Reset
button (S1) on the phyCORE Development Board LD 5V to start
the previously downloaded monitor kernel.
•
To start the µVision2 debug environment, click on the debugger
icon
on the
µ
Vision2 toolbar. A pop-up window will appear
indicating that this is an evaluation version. Click on OK.
•
You will see a blue status bar from left to right at the bottom of
your screen indicating the download process of the debug
program.
If a problem occurs during data transfer, the following window will
appear:
•
Click on Settings and verify the COM port and the baud rate
(9.600 baud). Push the Reset button S2 on the phyCORE
Development Board LD 5V and click on Try Again.
