Photron Fastcam SA2, Hardware Manual

Page: 77 / 101

65 FASTCAM SA2 / SA2 RV Hardware Manual
4.1.1. Connecting the System and a PC
Connect the LAN cable to the system as shown below.
Insert the LAN cable into the "GIGABIT ETHER" connector.
4.1.2. Setting the IP Address
 When connecting the system to a PC or when connecting other Gigabit Ethernet interface
compatible Photron cameras, set each of those devices to a different IP address. Also, when
connecting the system to an existing network, do not use IP addresses that are already in use on
the network.

For the procedure for setting the IP address of the system, refer to the "Photron FASTCAM Viewer
User's Manual" or the "LCD Remote Controller User's Manual".
4.1.3. Using DHCP (Dynamic Host Configuration Protocol)
The system is compatible with DHCP. In an environment where DHCP is used, the system's IP
address can be acquired from the DHCP server.