Photron FASTCAM SA-X2, Hardware Manual

Page: 21 / 74

FASTCAM SA-X2 21
1.2 Part Names
1.2.4 Status Display LEDs on the Rear of the Camera Body
There are a number of LEDs on the rear of the system's camera body. These LEDs indicate the
status of the system. The function of each LED is explained here.
■Illumination/blinking in operational states
• During low light mode operation
LEDs other than POWER (green) and IFLINK/TRANS (red) blink at a regular interval.
• When calibration is run from USER SW or the remote controller
LEDs other than POWER (green) and IF LINK/TRANS (red) blink alternately from right to left
three times and from left to right three times.
• During the Gigabit Ethernet interface initialization
LEDs other than POWER (green) and IF LINK/TRANS (red) blink alternately from right to left and
from left to right a number of times.
Col
or
LED ON LED FLASHING LED OFF
POWER Power On ― Power Off
IF LINK
/TRANS
The Gigabit Ethernet
interface is connected
Data is transferring The Gigabit Ethernet
interface is not connected
TRIGGER A trigger signal is present
(being input) (The LED will
illuminate for 0.1 second when
the trigger signal is input.)
― The trigger signal is not
present
IRIG The IRIG/GPS signal is present
(being input)
― The IRIG/GPS signal is not
present
SYNC MODE In external synchronization
mode (synchronized to an
external signal)
― In internal synchronization
mode (synchronized to the
internal signal)
SYNC IN A synchronization signal is
present (being input)
― A synchronization signal is
not present
REC READY Ready to record ENDLESS recording
(The REC (Red) LED
is also flashing)
Not ready to record
REC Ready to record (The case of
RANDOM types trigger mode)
Recording Not recording
For how to initialize the Gigabit Ethernet interface, refer to "1.2.5 Programmable Switch (USER SW)",
page 22.