FASTCAM-PCI R2 Hardware Manual
- 25 -
2.4.2.2.3. Multiple-PC Sync Operation with Multiple-PCI R2 Cameras
The following is an example of connection involving two PC’s and eight PCI R2 cameras. This
connection is highly recommended to avoid possible delay of sync and trigger signals between
cameras (see Subsection 3.4. Timing Charts). The basic connection (shown in 2.4.2.2.1) works
but is not recommended because of greater signal delays. Use it for software triggering only.
Trigger
Generator
PC 1
PC 2
Master Mode
Slave Mode
Slave Mode
Slave Mode
Camera ID: 0
Camera ID: 1
Camera ID: 2
Camera ID: 3
SYNC IN
SYNC OUT
TRIG OUT
T-TTL/SW IN
SYNC OUT
TRIG OUT
SYNC IN
SYNC OUT
TRIG OUT
T-TTL/SW IN
SYNC IN
SYNC OUT
TRIG OUT
T-TTL/SW IN
T-TTL/SW IN
SYNC IN
External Sync Mode
Slave Mode
Slave Mode
Slave Mode
Camera ID: 0
Camera ID: 1
Camera ID: 2
Camera ID: 3
SYNC IN
SYNC OUT
TRIG OUT
T-TTL/SW IN
SYNC OUT
TRIG OUT
SYNC IN
SYNC OUT
TRIG OUT
T-TTL/SW IN
SYNC IN
SYNC OUT
TRIG OUT
T-TTL/SW IN
T-TTL/SW IN
SYNC IN
Recommended Connection
Note: Camera parameters must be
Set up on each PC individually.
Summary of Contents for FASTCAM-PCI R2
