FASTCAM-PCI R2 Hardware Manual
- 27 -
2.4.4. Setting Up Software
Once the setups of the hardware for multiple-camera sync operation procedures in the previous
pages are completed, the system can be activated by the software. Follow the below procedure to
set up software. For details of software operation, see the Software User’s Manual.
2.4.4.1. Setting Up Master Board
For sync operation of multiple FASTCAM-PCI R2 cameras:
1) Select the camera ID number of the master camera of this system from the camera selection
box.
Note: For the relationship between Camera No. and Camera ID, see [Device Information] in [Help].
2) Press the ‘More’ button to set up more details.
3) Select the desired polarity of sync signal from the ‘Ext Sync Out’ box.
Note: The polarity of sync signal must match that selected for the slave board.
Summary of Contents for FASTCAM-PCI R2
