FASTCAM-512PCI Hardware Manual
- 10 -
6.
Replace the covers on the PC following the PC instruction manual.
7
．
Connect the camera cable to the camera connector on the Grabber Board. Be careful about
the connector orientation. Fasten the retaining screws tightly. Pull the cable lightly to check if
the connector does not come loose.
Turn off the PC and unplug the power cord before installing the Grabber Board in the PC.
Be sure to tightly fasten the retaining screws on the camera cable connector shell to avoid damage
to the system by an accidental disconnection during operation.
In case the board guide of the grabber board does not fit the slot, readjust the guide board or
remove it to insert the grabber board. Do not force the grabber board into a slot, or it may cause a
distortion on the grabber board that may eventually result in malfunctioning.
Slanted
Correctly Installed
Be sure the grabber board has been installed in the PCI slot squarely and tightly with its bottom
edge parallel to the PCI slot. Loose or slanted installation may damage the grabber board.
Retaining Screw
PCI Bus Slot
Please tight the connector lock and the screw firmly.
