Page
16
/
34
Chapter 7 Function Interface Introduction
7.1 Main interface of input function
Double- click in the function button
, and the input function interface as shown in the Figure 7.1 below pops
up.
Figure 7.1 Channel input module
As shown in the Figure 7.1, the phase polarity, mute, and input modes of the corresponding input channels can be
operated; in the input mode, analog input, digital input, and test signal can be selected from one of three, and a channel
can only have one input mode.
In this software, only products with D4 display support Dante function, Dante digital input supports CHA- CHD four
channels, and output supports Out1- Out4 channels; without Dante function, this button will become unavailable
.
7.2 Test signal function
In Figure 7.1 above, click the "Settings" button on the right side of "Test Signal" to pop up the test signal interface in
Figure 7.2 below.
