15
Acapela 16
English
Overview
These pages give a complete overview of a single channel at any one time. These pages are available by pushing
the Channel 1 to 8, Channel 9 to 16, Channel 17/18, Multi 1-4 and Main buttons. You can select a new channel
to view in the top right-hand side of the screen by pushing the left and right buttons. The overview picture for
channels can be found below, while the Main overview screen can be found at the bottom of the next page.
These pages offer any combination of the following functions:
EQ On/Off and Display:
This button will allow users
to turn on the channel’s EQ. If left inactive, the EQ
will be bypassed. The accompanying display will
show the channel’s currently selected EQ curve (as
selected by the user within the Equalizer function).
Selecting the display window will jump directly to the
Equalizer function and allow users to immediately
adjust EQ properties. An output level meter for the
EQ can also be found next to the EQ curve chart.
Dynamic Processor On/Off and Display:
This but-
ton will turn the Dynamic Processor on and off. As
with the EQ, all dynamic processors will be bypassed
if this button is left inactive. Also like the EQ function,
the accompanying graph will display the properties of
the currently selected Dynamic Processor. Select the
display to jump immediately to the dynamic processor
setup. Immediately next to the display, users can
find an output level meter for the channel’s dynamic
processor.
Dynamic Processor Selection and On/Off Buttons:
With these buttons, users can activate and deactivate
the corresponding dynamic processor functions, as
well as view their properties on the Master Dynamic
Processor Display (located to the left of these but-
tons). Available Dynamic Processors are: Gate,
Expander, Compressor and Limiter. The buttons
will turn yellow when their corresponding dynamic
process is being triggered (ie. when the threshold
has been passed).
Delay Function:
Push the delay button to activate
and deactivate the delay function for the currently
selected channel. Users can also adjust the delay
time itself.
Processing Order:
Use this function to select the
order that the audio signal will pass through the
Dynamic Processor, EQ and Delay. Any order made
up of the three processes can be selected. On the
Main mix, this can also be used to change between
an EQ and GEQ.
