![background image](http://html1.mh-extra.com/html/phoenix/ila-1000/ila-1000_instruction-manual_1551153009.webp)
© Copyright 2018, Phoenix Professional Audio GmbH, www.phoenix-pa.com
Phoenix logo is registered with the DE Patent and Trademark Office (TM)
All trademarks are the property of their respective owners
Instruction manual
- 8 -
ILA-1000
™
REAR SIDE / CONNECTIONS
1
2
3
4
5
6
7
8
9
10
7.- SWITCH/DIP Switch GAIN/PHANTOM
DIP-1 (ON)
— the sensitivity of the input is increased by +15 dB;
DIP-1 (OFF) —
default sensitivity of input is set;
DIP-2 (ON) —
the MIC.-2 / LINE input is supplied with 15VDC phantom power for condenser microphones;
DIP-2 (OFF)
— phantom power is disabled.
8.- MIC.2/LINE INPUT
The input is balanced (+2), (-3), (1-shielding) - see diagram.
The input sensitivity is set on the front panel with separate MIC.2/LINE control and via DIP-1 or
MODE-SWITCH.
MODE-SWITCH MIC.-LINE
This switch sets the sensitivity of the MIC.2/LINE input between microphone and line level.
DIP-1 (ON) — the sensitivity of the input is increased by +15 dB.
DIP-1 (OFF) — Default sensitivity of input is set.
ATTENTION
All XLR inputs have a switchable phantom power 15VDC, DIP-2 (ON position).
If unbalanced, dynamic microphones are connected to the audio inputs, a coupling capacitor must be inserted
or the phantom power switched off, DIP-2 (OFF position).
Unbalanced inputs: Strip the wire conductors by 6 mm and
connect them to the terminals as shown. The center pin
must be connected to the shielding pin as shown. Tighten
the screws.
1 GND
2 +IN
3 -IN
1 GND und wire bridge to 3
2 +IN
Balanced inputs: Strip the wire conductors by 6 mm
and connect them to the terminals as shown. Tighten
the screws.