![background image](http://html1.mh-extra.com/html/phoenix/ila-1000/ila-1000_instruction-manual_1551153008.webp)
© Copyright 2018, Phoenix Professional Audio GmbH, www.phoenix-pa.com
Phoenix logo is registered with the DE Patent and Trademark Office (TM)
All trademarks are the property of their respective owners
Instruction manual
- 7 -
ILA-1000
™
REAR SIDE / CONNECTIONS
1.- LOOP CABLE
SPEAKON socket 2-pin, the loop cable should be connected to the terminals (+ pin) and (- pin).
2.- AMPLIFIER/LOOP CONTROL
Fault signaling output 15VDC. The contact remains potential-free, if the amplifier and the induction loop are
working without interruption. The contact is supplied with 15VDC voltage as long as there is a system fault or
loop fault.
3.- DC OUTPUT (+15VDC/-15VDC)
Balanced output v/- 15VDC, used to connect or power a phase shifter FS-1.
4.- INSERT
The INSERT socket is unbalanced. It is used to connect external signal processing equipment such as additional
EQ‘s or FS-1 phase shifter. If the plug is not plugged in or if no additional device is connected to INSERT, the
signal path is bridged.
5.- LINE OUTPUT [LINE-OUT]
Balanced audio signal output to JACK socket (0 dB maximum).
6.- MODE-SWITCH MIC.-LINE
This switch determines the sensitivity of the MIC.2/LINE input.
Switchable between microphone level and line level.
Attention:
Always set the correct input sensitivity, otherwise an excessive signal level is reached at the input despite the
automatic device (setting on MIC and input signal with LINE level) so that the amplifier can not process the
signal properly and the signal is distorted at the loop output
1
2
3
4
5
6
7
8
9
10