Before putting the induction loop amplifier ILA-1000 into operation, we ask you to carefully read the safety
instructions.
We ask you to perform the installation according to the following guidelines:
In a highly visible position, an INDUCTIVE COUPLING sign should be located near the entrance to the area
where an induction loop is installed.
1 - Always place the amplifier on a flat and stable surface.
2 - Choose a dry environment and do not put liquids on the amplifier.
3 - Avoid the proximity of heat sources.
4 - Never open the case of the amplifier without disconnecting the power plug from the socket.
5 - Only connect the device to 230 VAC mains voltage.
- Heat sink with a temperature-controlled fan control
- Short Circuit Protection - Overheat Protection - Open Circuit Protection - Overload Protection and
Overload Protection
- LED level display „compressor“
- LED level display „output level“
- LED display loop detector „ERROR“
- LED - display temperature „TEMP“
- LED display overload „OVERLOAD“
- LED display „System POWER-ON“
- SOFT START and MEASURING with flashing „POWER LED“
- Balanced microphone / line inputs
- INSERT PORT Input/Output
- Phoenix connections for LOOP line
- Phoenix connection for LOOP CONTROL
- Separate volume control for all inputs
- Recessed volume controls, LF/HF EQ controls and MLC front panel controls
- Compression LED display 3 to 33 dB
- Output level LED display -27 to 0 dB
- Switchable phantom power (DIP switch on the back)
- Connectable GAIN system (signal increase by + 15dB)
- 19“ brackets can be removed for table version
- Space-saving 1 U housing version
- Monitoring of the loop impedance in the range from 0.5 ohms to 3.0 ohms
© Copyright 2018, Phoenix Professional Audio GmbH, www.phoenix-pa.com
Phoenix logo is registered with the DE Patent and Trademark Office (TM)
All trademarks are the property of their respective owners
Instruction manual
- 4 -
ILA-1000
™
SAFETY INSTRUCTIONS
KEY FEATURES