10.- ERROR
Loop impedance fault indication (Impedance not in the range of 0.5 - 3.0 ohms).
IMPORTANT:
After eliminating the fault, always
reset the loop amplifier ILA-1000 by switching off the amplifier with the
POWER button, wait 3 seconds and turn it on again with the POWER button.
The measuring cycle (PILOT TONE) is reactivated and the POWER LED flashes..
11.- TEMP
Error message display; the amplifier temperature is too high (in this state the amplifier is deactivated)
12.- POWER - Power indicator
State-1 LED flashes, system measurement is in progress and the turn-on delay is active.
State-2 LED is lit, the system is activated and loop impedance measurement is completed.
13.- OVERLOAD
Overload indicator, LED lights or flashes when overload is detected, the
LIMITER is activated.
14.- ON/OFF - Power switch
© Copyright 2018, Phoenix Professional Audio GmbH, www.phoenix-pa.com
Phoenix logo is registered with the DE Patent and Trademark Office (TM)
All trademarks are the property of their respective owners
Instruction manual
- 6 -
ILA-1000
™
FRONT
1
2
3
4
5
6
7
8
9 10 11
12 13
14