8
e)
Quick release „GQR“ (optional)
In the event of a power failure the drive can be reset via the optional quick release.
Actuating the quick release causes the drive to travel back to the starting position.
GQR
9
c)
Electrical Connection
In the
Operating Instructions
to be issued by you, point out to the operator that if leads, in
particular the
connection lead
, are
driven over
they could sustain damage.
Mechanical
loads should also be avoided.
When routing the leads
make sure
that they...
Ÿ
cannot get caught up or trapped,
Ÿ
are not subjected to mechanical loads (i.e. do not pull, apply pressure or bend),
Ÿ
cannot get damaged in any other way.
Make sure that the cables, in particular the
connection lead
, are fastened to the end
product with adequate
strain relief
and
kink protection
and that suitable constructional
measures prevent the
connection lead from trailing on the floor
when the end product is
being
moved
.
D)
Dismantling
Operate the furniture to travel to the starting position, then isolate
drive (2)
from the
DewertOkin controls. When removing
BEK bolts (3, 8)
, it is
security clip (4, 9)
and
important to
support drive (2)
, as this is released instantly!
Recommended arrangement of the fittings
Besides precise alignment of the fittings, we recommend using only one fixing bracket
(a)
at
either side of the fittings. This measure reduces the risk of a misalignment of the two fixing
brackets which would cause the drive unit to tilt. The actuator must always be fixed, so that it
is restrained, but adequate free to move on its mountings. The actuator must be fixed in such
a way that it is protected from twisting and deformation in all positions. Fittings with two fixing
brackets
(b)
can be used, but these must be precisely aligned to ensure that the withdrawal
force does not increase.
Fix the bracket on the one side to utilize the elongated hole. This permits any possible diffe-
rences in length between the fitting dimension of the drive and your application to be appro-
priately adjusted.
Recommendation
: the elongated hole (c) should offer at least 2mm play.
(a)
(b)
(c)
MEGAMAT 4
03/2020
ID 59400 9.0
03/2020
ID 59400 9.0