RAD-900-...
PHOENIX CONTACT
3827_en_B
5.5.2
Reading the memory stick
Reading in common network parameters via the memory stick
1.
Insert the memory stick in the S port of the wireless module.
2.
Press the SET button located on the wireless module and hold down for at least one
second. Parameter read in is started. Read in has been completed when the DAT LED
lights up once. The new parameters are activated.
3.
Remove the memory stick from the wireless module.
Reading in common network parameters and individual device parameters via the
memory stick
This function enables all common network parameters and individual device parameters to
be read into the wireless module. A full copy of devices can be created, e.g., as a backup
copy.
1.
Insert the memory stick in the S port of the wireless module.
2.
Press the SET button located on the wireless module and hold down for at least six
seconds. Parameter read in is started, the DAT LED flashes.
3.
The read in process has been completed once the DAT LED stops flashing. The new
parameters are activated.
4.
Remove the memory stick from the wireless module.
5.6
Configuration via PSI-CONF software
You can make special settings using the PSI-CONF configuration and diagnostics software.
The software is available to download at
phoenixcontact.net/products
. A PC with a
Windows operating system is required to use the software. Use the RAD-CABLE-USB
(Order No. 2903447) USB cable for configuration and diagnostics.
Install the software and the USB driver for the RAD-CABLE-USB cable. Follow the software
wizard.
If an error is detected while saving or checking the data, the DAT and ERR LEDs flash
simultaneously.
WARNING: Explosion hazard when used in potentially explosive areas
The USB cable must
not
be used in potentially explosive areas.
For additional information on the USB cable, please refer to the RAD-CABLE-USB
package slip. The latest documentation can be downloaded at