Function test
108366_en_01
PHOENIX CONTACT
Starting situation:
the actuator is not within the response area / the safety equipment is
open.
1.
Switch on the operating voltage on the safety switch.
Expected machine behavior:
–
The machine must
not
start up automatically.
Expected behavior of the safety switch:
–
The green STATE LED flashes quickly, 5 Hz.
The sensor is performing a self-test for 5 s, approximately.
–
In the case of
multicode and fixcode sensors
:
The green STATE LED flashes cyclically: green short, off long.
The sensor indicates normal mode with open safety equipment.
–
In the case of
unicode sensors
:
The green STATE LED flashes cyclically: 2 x green, off long.
The sensor is ready to learn.
2.
Close all safety equipment.
Expected machine behavior:
–
The machine must
not
start up automatically.
Expected behavior of the safety switch:
–
For
automatic
startup behavior:
The green STATE LED is permanently on.
The sensor indicates normal mode with closed safety equipment.
–
For
manual, monitored
start behavior:
The green STATE LED flashes slowly, 1 Hz.
The sensor is waiting for a start command via the reset button.
3.
Enter a start command for the machine via your controller.
a)
If provided: press the reset button. Release it again.
Expected machine behavior:
–
The machine starts up.
Expected behavior of the safety switch:
The green STATE LED is permanently on.
The sensor indicates normal mode with closed safety equipment.
4.
Open the first safety equipment.
Expected machine behavior:
–
The machine
must be
switched off.
–
It must
not
be possible to start the machine as long as the safety equipment is open.
Expected behavior of the safety switch:
–
The green STATE LED flashes cyclically: green short, off long.
The sensor indicates normal mode with open safety equipment.
5.
Repeat steps 1 to 4 individually for each safety equipment.