Phoenix Contact 1153079, Installation And Startup Manual

Page: 34 / 54

FL MGUARD 1000 product family
34 / 52
PHOENIX CONTACT 108413_en_06
Obtaining the IP setting
per DHCP
To automatically obtain the IP setting of the configuration computer, proceed as follows;
• Open the Windows start menu and type “Control Panel” .
• Open ( Network and Internet ) / Network and Sharing Center
• Click on “ Change adapter settings ”.
• Right-click the desired network adapter and select the “ Properties ” command.
• Double-click on “ Internet Protocol, Version 4 (TCP/IPv4) ”.
Figure 4 - 4 Changing the IP setting of the configuration computer (admin PC)
• Select “ Obtain an IP address automatically ”.
• Confirm with “ OK ”.
⇒ The device assigns an IP address from subnet 192.168.1.0/24 (e.g.
192.168.1.100) to the configuration computer.
⇒ The device serves as default gateway for the configuration computer.
Manually entering a static
IP setting
To configure static IP settings for the configuration computer (Windows), proceed as fol -
lows:
• Open the Windows start menu and type “Control Panel” .
• Proceed as described above.
• Select “ Use the following IP address ”.
– Enter the values in accordance with the example in Figure 4 - 4 / Table 4 - 1 .
• Confirm with “ OK ”.
⇒ You have assigned an IP address from subnet 192.168.1.0/24 to the configuration
computer.
⇒ The device serves as default gateway for the configuration computer.
Testing the connection To test whether a configuration computer can reach the device via the network, proceed as
follows:
• Open the Windows start menu and type “cmd” to open a command line.
• Enter the command “ ping 192.168.1.1 ” and press the Enter button.