WelcomeEye / Link / V1
F10
-
For permanent use
: download the Philips WelcomeHome app onto the new
phone and log in using the email address and password of your main account.
-
For temporary access
: we recommend that you create a new user. You will find
the procedure for this in chapter 9 “Advanced settings” of the full downloadable
instructions on
www.philips.com
.
5. RESETTING
In the event of an error, or if you wish to reset the intercom panel, press the black button
(next to the micro SD card) and hold for approximately 10 seconds, then resume the
procedure from step I.
The call button flashing red indicates that the reset has been successful.
6. INSTALLATION AND WIRING
Before placing the intercom panel in its permanent position, we recommend that you check
the WiFi connection.
If the panel connects to your WiFi network, you can then proceed with the permanent
installation.
If you are positioning the device outside the range of your Internet router, it might be
necessary to use an external WiFi terminal.
Important:
do not expose the camera to direct sunlight or position it facing a reflective
surface.
Tip:
we recommend that the control wires for a motorised gate be passed through a sheath
to protect them from impacts and bad weather.
Step 1. :
The intercom panel is fitted at a height of approximately 1.60m.
(Don’t forget to connect the access control wires, if you plan to have access control.)
You can either:
- Use the double-sided tape provided. The bonding surface must be completely smooth
Summary of Contents for WelcomeEye Link 531034
Page 2: ...WelcomeEye Link V1 2 ...
Page 39: ...WelcomeEye Link V1 F37 ...