Trimming eyebrows
Use the tip to cut individual eyebrow hairs.
Do not use the appliance to define or trim the entire eyebrow.
Never try to trim your eyelashes.Never come too close to
your eyes!
1
Place the tip of the attachment on the upper edge of
the eyebrow.
2
Move it along the edge of the eyebrow from the base of
the nose towards the outer tip of the eyebrow (fig. 17).
Cleaning
.
Do not use water or a moist cloth to clean this appliance.
Do not use abrasives, scourers or liquids such as
alcohol, petrol or acetone to clean the appliance.
1
Remove the comb (fig. 9).
2
Remove the attachment (fig. 10).
3
Blow and/or shake out any hair that may have
accumulated in the attachment.
4
Clean the outside and inside of the attachment with the
brush supplied (fig. 18).
5
Place the attachment back onto the appliance.
Storage
.
◗
Store the appliance and attachments in the stand to
prevent damage (fig. 19).
Replacement
.
Worn or damaged attachments should only be replaced with
original Philips replacement attachments, which are available
from your dealer or an authorised Philips service centre.
If you have any difficulties obtaining replacement attachments
for your appliance, contact the Philips Customer Care Centre
in your country or consult the worldwide guarantee leaflet.
Environment
.
◗
Do not throw the appliance away with the normal
household waste at the end of its life, but hand it in at
an official collection point for recycling. By doing this
you will help to preserve the environment (fig. 20).
The built-in rechargeable battery contains substances that
may pollute the environment. Always remove the battery
before discarding the appliance or handing it in at an official
collection point. Dispose of the battery at an official
collection point for batteries. If you have trouble removing
the battery, you can also take the appliance to a Philips
service centre, which will remove the battery for you and will
dispose of it in an environmentally safe way.
Disposal of the battery
1
Remove the powerplug from the wall socket and pull
the appliance plug out of the appliance.
2
Let the appliance run until the motor stops.
3
Insert a screwdriver in the groove next to the shaft at
the top of the appliance.Turn the screwdriver to
separate the two housing halves (fig. 21).
4
Lift the battery out of the housing by means of a
screwdriver. Twist the connecting wires until they
break (fig. 22).
Do not connect the appliance to the mains again after the
battery has been removed.
Guarantee & service
.
If you need information or if you have a problem, please visit
the Philips website at
www.philips.com
or contact the Philips
Customer Care Centre in your country (you will find its
phone number in the worldwide guarantee leaflet). If there is
no Customer Care Centre in your country, turn to your local
Philips dealer or contact the Service Department of Philips
Domestic Appliances and Personal Care BV.
Remaining hair length (mm)
2
4
6
8
10
12
14
16
18
Setting
1
2
3
4
5
6
7
8
9
Table 1. Beard trimmer
4203 000 53682
3/11
