Mechanical Instructions
EN 9
LC4.9E AB
4.
The aluminium stands (order code 3122 785 90480) can be
mounted with the back cover removed or still left on. So, the
stand can be used to store products or to do measurements. It
is also very suitable to perform duration tests without taking
much space, without having the risk of overheating, or the risk
of products falling. The stands can be mounted and removed
quick and easy with use of the delivered screws that can be
tightened and loosened manually without the use of tools. See
figure above.
Note:
Only use the delivered screws to mount the monitor to
the stands.
4.3
Assy/Panel Removal
4.3.1
Rear Cover
Figure 4-4 Rear cover
Warning:
Disconnect the mains power cord before you remove
the rear cover.
1.
Remove the screws that secure the rear cover (see Figure
“Rear cover screws”); these are:
a) 4 x big torx screws (1) for securing the stand/wall mount;
b) 5 x small torx screws (2) near the rear I/O panel;
c) 22 x small torx screws (3) that secure the loudspeaker
compartments [6 of these screws are in sunken holes (4) ]
and along the edges of the rear cover.
2.
Lift the rear cover from the cabinet cautiously. Make sure
that wires and other internal components are not damaged
during cover removal.
4.3.2
Cover Shield for IBO-zapper & SSB
Figure 4-5 Cover shield
Figure 4-6 DVI-I & SPDIF connector screws
1.
Very
cautiously
disconnect the LVDS cable (1) from the
SSB panel (see Figure “Cover shield”). Notice that this
cable is very fragile.
2.
Unplug the black cable coming from the IBO zapper/SSB
board from the Audio/STBY board (see Figure “Cover
shield”).
3.
Remove all other cables (2) from the IBO zapper/SSB
board (see Figure “Cover shield”).
4.
Remove the 5 fixation screws that connect the top
shielding with the bottom shielding, and also the 2 fixation
screws that connect it with the rear connector plate, see
Figure “Cover shield”.
5.
Remove the fixation screws from the DVI-I connector and
from the SPDIF connector, see Figure “DVI-I & SPDIF
connector screws (1)”.
6.
Remove the upper part of the shield (with the IBO zapper
attached to it) from the lower part of the shield (on which
the SSB board is located), by unhooking it from its
brackets. Be careful not to damage the LVDS connector on
the SSB board, see Figure “Cover shield”.
7.
Finally, remove the IBO zapper (attached to the top
shielding with 4 screws), and the SSB board (attached to
the lower shielding with 2 screws), see Figure “IBO zapper
& SSB”.
Figure 4-7 IBO-zapper & SSB
F_15420_034.eps
070605
1
2
3
3
3
4
4
4
4
3
3
3
3
3
3
F_15660_009.eps
280705
2
3
3
1
F_15660_010.eps
280705
1
F_15660_008.eps
280705
