Philips ErgoLine D310, Manual

Page: 26 / 88

ErgoLine D330/D340
Customer Engineer Manual
Page 2-6
Connecting the D330 ErgoLine Terminal
The D330 ErgoLine terminal is connected as follows:
1. Connect the handset cord to the handset port on the underside of the
ErgoLine terminal and put the handset on the cradle.
2. Connect any other equipment to the appropriate connectors as necessary:
•
PC interface
3. Connect the telephone line cord to the line port on the underside of the
ErgoLine terminal.
4. Plug in the telephone line cord at the PNT1 or the wall socket.
When the ErgoLine terminal has been successfully connected to the following:
•
PNT1 or wall socket
The following display will appear on the screen:
The ErgoLine terminal is now ready to receive commands from the Switch.
Programming the ErgoLine terminal is possible before download, however call set-
up is not possible during this time. The default values can be overruled by the
Switch or can be changed by the programming procedure from the ErgoLine
terminal.
When the message
Non-Operational
is removed, which can take a few
moments, dial tone will be received upon lifting the handset.
The following display will appear on the screen:
Note:
If no dial tone is received, check the status of the circuit in the Switch.
Non-Operational
27/06/96 14:33