&
4.4 INSTALLATION / FACTORY SETTING
After entering the following number combination in the «change PIN» menu, you can reset
changes to the unit settings and restore your unit to its delivery condition (factory setting).
To do this select the «change PIN» menu Key
M
> Channels > Minor Protection > PIN
1.
Enter the current PIN:
X X X X X
= the PIN changed by you
or:
0 0 0 0 0
= delivery condition
2.
Enter the following PIN:
1 1 1 1 1
3.
Enter the following PIN:
9 9 9 9 9
All unit settings are reset to the default factory settings:
PIN (protection code): . . . . . . . . . . . . . . . .
0 0 0 0 0
Time offset: . . . . . . . . . . . . . . . . . . . . . . .
+1h
or
+2h
, according to date of manufacture
Menu language: . . . . . . . . . . . . . . . . . . . .
German
Signal paths:
TV SCART . . . . . . . . . . .
RGB
VCR Scart . . . . . . . . . . .
CVBS
TV -> VCR . . . . . . . . . . .
ON
VCR signal . . . . . . . . . . .
RGB/CVBS
Picture format . . . . . . . .
4 : 3
VCR record . . . . . . . . . .
Standard
Digital audio . . . . . . . . . .
Standard
LNB
LNB . . . . . . . . . . . . . . . .
ON
In standby . . . . . . . . . . .
OFF
DiSEqC
22kHz signal . . . . . . . . .
High/Low
Tone burst . . . . . . . . . . .
OFF
DiSEqC . . . . . . . . . . . . .
ON
DiSEqC repeat . . . . . . . .
OFF
Satellites:
Enabling ASTRA . . . . . .
ON
Enabling HOTBIRD . . . .
ON
LO1 . . . . . . . . . . . . . . . .
9750 MHz
LO2 . . . . . . . . . . . . . . . .
10600 MHz
Orbit pos. ASTRA . . . . . .
1
Orbit pos. HOTBIRD . . . .
2
Uncom. switch . . . . . . . .
OFF
Names of the favourite lists . . . . . . . . . . . .
according to delivery condition
N.B.:
Check that the time offset is correct and change the menu language as required.
Please note that any changed PIN is also set to 00000.
4.4.1 Time offset
After switching on at the mains switch or after a power cut the time and date for the system clock
(timer) are transferred from the data received. To ensure that the time and date of the receiver
correspond to local time, a value for the deviation from standard time must be entered.
The offset value for CET summer time is {+2} hours, for CET winter time {+1} hour.
Please check or, if need be, correct the time offset value when setting up your equipment
and also when the time changes in spring and autumn.
(1)
Select using key
1
or using the
9 8
keys, then activate using the
OK
key and set the
desired time offset value using the
* +
keys. Confirm the modifications using the
OK
key.
N.B.:
If an incorrect time offset value is entered, programme times will be indicated
incorrectly.
