Introduction 5
DreamStation BiPAP autoSV User Manual
Maintenance
Never operate the device if any parts are damaged or if it is not working properly.
Replace damaged parts before continuing use.
Periodically inspect electrical cords, cables, tubing, and accessories for damage or
signs of wear. Discontinue use and replace if damaged.
Repairs and adjustments must be performed by Philips Respironics-authorized
service personnel only. Unauthorized service could cause injury, invalidate the
warranty, or result in costly device damage. Contact your home care service provider
for maintenance.
Cleaning
To avoid electrical shock, always unplug the power cord from the wall outlet before
cleaning the device.
Do not immerse the device in any fluids or spray the device with water or cleaners.
Clean the device with a cloth dampened with an approved cleaner.
Humidifier
For safe operation when using a humidifier, the humidifier must always be positioned
below the breathing circuit connection at the mask. The humidifier must be level for
proper operation.
1.3.2
Cautions
A caution indicates the possibility of damage to the device.
Electrostatic
Discharge (ESD)
Do not use antistatic or conductive hoses or conductive patient tubing with the
device.
Pins of connectors marked with the ESD warning symbol shall not be touched
and connections shall not be made without special precautions. Precautionary
procedures include methods to prevent build-up of electrostatic charge (e.g., air
conditioning, humidification, conductive floor coverings, non-synthetic clothing),
discharging one’s body to the frame of the equipment or system or to earth. It is
recommended that all individuals that will handle this device understand these
precautionary procedures at a minimum as part of their training.
Before operating the device, ensure that the SD card/filter access door and the
modem access door are both closed whenever any of the accessories such as the
Link Module or Modem are not installed. Refer to the instructions that came with
your accessory.
Condensation
Condensation may damage the device. If the device has been exposed to either
very hot or very cold temperatures, allow it to adjust to room temperature (operating
temperature) before starting therapy. Do not operate the device outside of the
operating temperature range shown in the Specifications chapter later in this manual.
