Configuring the Wireless ADSL Modem Routerr
15
If the connection is inactive for longer than the maximum idle time, it
will perform system logout, and you have to log in again to access the
management interface. (Default: 10 minutes)
Remote Management:
By default, management access is only available to users on your local
network. However, you can also manage the ADSL Wireless Base
Station from a remote host by entering the IP address of a remote
computer on this screen. Check the Enabled check box, and enter the
IP address of the Host Address and click "SAVE SETTINGS".
Note
If you check Enable and specify an IP address of 0.0.0.0, any remote host
can manage the ADSL Wireless Base Station.
For remote management via WAN IP address you need to connect
using port 8080. Simply enter WAN IP address followed by :8080, for
example, 212.120.68.20:8080.
4.6.4 SNMP
Use the SNMP configuration screen to display and modify parameters
for the Simple Network Management Protocol (SNMP)
SNMP community:
A computer attached to the network, called a Network Management
Station (NMS), can be used to access this information. Access rights to
the agent are controlled by community strings. To communicate with
the ADSL Wireless Base Station, the NMS must first submit a valid
community string for authentication.
Note
Up to five community names may be entered.
SNMP Trap:
Specify the IP address of the NMS to notify when a significant event is
detected by the agent. When a trap condition occurs, the SNMP agent
sends an SNMP trap message to any NMS specified as a trap receiver.
4.7
UPNP
UPNP (Universal Plug and Play) settings
With Universal Plug and Play, a device can automatically join a network,
obtain an IP address, communicate its capabilities, and learn about the
presence and capabilities of other devices. Devices can then directly
communicate with each other. This further enables peer-to-peer
networking.
4.8
QoS
The QoS Settings page allows the user to configure the bandwidth
allocation for each forwarding behavior. The QoS settings are described
below:
Name - Displays the name of the forwarding method, i.e., Best Effort,
Assured Forwarding or Expedited Forwarding.
Description - Briefly describes the forwarding method employed.
Priority - Best Effort will have lowest priority as it is a basic connectivity
service with no guarantees. Expeditd Forwarding will have highest
priority. It provides low delay, low jitter and low loss delivery of
packets.
Bandwidth Allocation - You choose the minimum bandwidth for each
forwarding method.
Parameters
Description
Community
A community name authorized for
management access
Access
Management access is restricted to Read Only
(Read) or Read/Write (Write)
Valid
Enables/Disables the entry
