Philips BDL6531E/00, Service Manual

Page: 70 / 130

70 BDL6531E LCD
General Product Specification
2.5.2 Power consumption
•
Normal on - 500 w (typical), 550 w(max.)
•
Standby - < 1w, RC standby mode
•
Switch off (DC or TACT) - < 1w, RC in-active
•
Switch off (AC mains) - < No power consumption.
2.5.3 Display DPM standby (D-sub & HDMI input)
z DPM -The Display enters DPM off (sleep) mode when no H&V sync, one of H-sync
/ V-sync input or digital clock is absent. “No Video Input” message appears before
entering DPM mode. A delay of 15 seconds before entering the power saving state
is required to avoid misunderstanding of display resolution and timing mode
changes.
z Recovery from DPM - Power & function recover when either H & V syncs or digital
clock are detected.
z Standby - The Display enters “AV standby mode” when it’s switched off by RC.
“Standby/Power” key or SLEEP TIMER function is activated or no AV
signal input for 15 seconds.
z Recovery from Standby - Power & function recovers when RC “Power” is
pressed.
2.6 User Control Interface
Controlled via top control keypads or remote control or RS-232.
2.6.1 Hidden controls
It can’t be easily accessed in front of the set.
To be revised according to new graphic sheet.
`
Key PC mode AV mode
DC switch power standby DC switch power standby
Decrease/Volume down Decrease/Volume down
Increase/Volume up Increase/Volume up
▲ MENU Select Down Menu Select Down/Channel Down
▼ MENU Select Up Menu Select Up/Channel up
MENU Enter /Exit OSD menu Enter /Exit OSD menu
ENTER
VIDEO SOURCE
To switch different video
source To switch different video source